How To Fit Your Frame Protection Kit

How To Fit Your Frame Protection Kit - Clear Design

Follow these instructions below if you have purchased either our Clear Gloss or Matt Clear designs (keep on scrolling for Graphical designs)


  1. Clean your bike thoroughly before application. For best results and optimum durability spray Muc-Off Disc Brake Cleaner or Dry Degreaser onto a clean, dry microfibre cloth and wipe over the surface to ensure it is contaminant free. (Always test the disc brake/dry degreaser cleaner on a small inconspicuous area prior to use to ensure finish compatibility!)
  2. Try to fit the guards in a clean and warm environment, this will help achieve good adhesion to the surface. Top Tip! If you are applying in colder conditions and have access to a hairdryer then carefully warm the surface. This will help achieve an optimal adhesive bond. 
  3. Spray your hands and the adhesive side of the guards with water then slowly peel the guards off the backing material and line up the centre of the guards to the area you are applying. NB: It’s important you start with each sticker in the dead centre of the area you are applying so chill and take your time on this section! Then slowly rub down the middle, working your way out to the sides pushing out any air bubbles to the edges. 

Top Tip!

You can easily trim the shapes as required, if necessary, with clean, sharp scissors if you need to fit around any challenging shapes or frame mounts etc.

  • Use a clean microfibre cloth to firmly rub down the guards onto the surface and make sure you cover all areas with even pressure.
  • Sit back and admire your freshly wrapped pride and joy, now go ride!

How To Fit Your Frame Protection Kit - Graphic Design

Follow these instructions below if you have purchased one of these patterned designs, including Punk, Camo, Bolt or Day Of The Shred:

  1. Clean your bike thoroughly before application. For best results and optimum durability spray Muc-Off Disc Brake Cleaner or Dry Degreaser onto a clean, dry microfibre cloth and wipe over the surface to ensure it is contaminant free. (Always test the disc brake/dry degreaser cleaner on a small inconspicuous area prior to use to ensure finish compatibility!) 
  2. Try to fit the guards in a clean and warm environment, this will help achieve good adhesion to the surface. Top Tip! If you are applying in colder conditions and have access to a hairdryer, then carefully warm the surface. This will help achieve an optimal adhesive bond. 
  3. Peel the guards off the backing material and line up the centre of the guards to the area you are applying. NB: It’s important you start with each sticker in the dead centre of the area you are applying so chill and take your time on this section! Then slowly rub down the middle, working your way out to the sides pushing out any air bubbles to the edges. Top Tip! You can easily trim the shapes as required, if necessary, with clean, sharp scissors if you need to fit around any challenging shapes or frame mounts etc. 
  4. Use a clean microfibre cloth to firmly rub down the guards onto the surface and make sure you cover all areas with even pressure. 
  5. Sit back and admire your freshly wrapped pride and joy, now go ride.